Oh Blush Gel and Powder - Base (15mL)

The Oh Blush Gel Base will give your Oh Blush Gel and powder coverage a better hold, in addition to limiting the chances of color shifting. The Oh Blush Gel Base is applied with the brush included in the bottle and must be cured in a UV or LED lamp.

The large Oh Blush family is expanding with the GEL range!

Oh Blush gel products allow for quick and easy application!
They are catalyzed in a UV or LED lamp.
They do not require any spray hardener, reducing the risk of allergies and intolerance to spray hardeners or acrylate-based products!
They can be used with all powders .

Preparation

1. Brush nails with soap and water;
2. Push back cuticles and file nails;
3. Choose and adjust prostheses (if applicable);
4. Run a yellow block over the nail and remove the dust;
5. Apply 2 coats of Oh Blush GEL PREP to the nail plate;
6. Glue the prosthetics with the Oh Blush DIP BASE & FINISH (if applicable).

Steps for applying the Oh Blush Gel and Powder system

1. Apply a very thin layer of Oh Blush GEL BASE and cure for 30 seconds under an 18W LED lamp or for 1 minute under a 36W UV lamp;
2. Remove excess with a dry brush;
3. Apply a very thin layer of Oh Blush DIP GEL;
4. Sprinkle the Oh Blush powder of your choice on the nail, shake to remove the excess, then clear the grooves with an orange stick;
5. Cure for 1 minute in a 36W UV or 18W LED lamp;
6. Repeat steps 1-3 to achieve desired strength and opacity;
7. Apply a very thin layer of Oh Blush DIP GEL and cure for 1 minute;
8. Remove the stickiness with 99% alcohol;
9. File nails to a smooth surface, then remove dust;
10. Finish with a coat of Oh Blush GEL FINISH, cure for 2 minutes in a 36W UV lamp or 30 seconds in an 18W LED lamp.

Removing an Oh Blush Gel and Powder Cover

File the nail surface, then soak your nails in Oh Blush NAIL POLISH REMOVER for 5 minutes.
Repeat until all traces of gel powder are gone.